Scaled up by 1% and it turned out perfectly, love the way it looks!
SodaStream Flavoring Bottle Organizer
A holder for 6 bottles of SodaStream brand water flavoring.
25
89
8
394
updated May 2, 2022
Makes
Comments
Printed with a 0.6mm nozzle and adaptive layers on my P1S. Scaled to 101% and the fit is perfect so the bottles don't rattle in the fridge anymore!
Nice print, keeps my bottles from tipping over making a sticky mess. The fit is tight so next one I do will scale it up 1 or 2 percent. Thank you!
Printed in PLA, 0.2mm resolution with variable layer height with 0.07mm at the top of the arches, 15% infill, no supports.
I printed this using the ends of some PLA rolls I had, as I was more concerned with utilitarian aspects of this model. I do love the model and have been using it consistently since I downloaded and printed it. I did not scale this, it prints cleanly, and I find the fit to be perfect for my use. Keeps SodaStream flavor bottles readily available, and organized, in my refrigerator.
Exactly what I was looking for. I scaled it 1% as recommended and the fit is great. Printed on Polymaker mat PLA.
LH 0.2
No support
10% infill
Fremover PLA+ Pink
Scaled 1.5% per other comments, which was perfect
Printed well and keeps the bottles from getting swallowed by the fridge. Maybe a little tight, so maybe increase size 1-2%.
Perfect for keeping my bottles from getting lost in my fridge. Fits the bottles well for the most part - a couple seemed a little snug, so maybe increase the size a percent or two. Then again, that may just be the tolerances of my machine.