a simple webcam stand with 2 parts (CAGE, STAND) which i created for my Ultimaker3 (maybe works with other models too? plz let me know!). The built in Webcam is nice, but i wanted an additional one on the top for streams.
So this one is put on the edge of the printer with 2 slots on the back (cage) for wires.
!!! It has a large 50° angle, because otherwise i wouldn't get a nice picture of the whole printing plate. So be careful that your webcam does not fall down into the printer. Check before use, WARRANTY EXCLUDED! Use a tape or sth if u need it to be fixed! ;)
GLUE THE CAGE TO THE STAND AT THE POSITION YOU PREFER, IT DOES NOT STICK TOGETHER BY ITSELF!!!
The small hole on the bottom of the CAGE fits to the STAND.
Download and try it out!
HF
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
Rafts:Yes
Supports:
Yes
Resolution:0.2mm
Infill:
50%
Notes:
The CAGE does not need any rafts, but for the STAND i suggest you use brim with 10mm.
Category: 3D Printer AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.