I wanted a simple solution for a photo studio lightbox that could be stored with minimal space.
Had the idea of using 3mm K-Line sheets and printing some parts to keep them together in a square.
All the pieces were printed in 0.3mm with 10% infill.
The front corner pieces can be printed like the below picture, has a lot of contact with the bed and each piece prints in under an hour.
↳ Front corner piece on PrusaSlicer
The back corner piece can be a bit trickier to print since it has a “slot” to insert the k-line in every axis. The solution I found was to print like the below picture, with minimal but strong support (honeycomb).
↳ Back corner piece on PrusaSlicer
Parts needed:
The author marked this model as their own original creation.