Slim Pwnagotchi + UPS Lite Case

I created this case to encorporate the Waveshare V4 Epaper display, together with the UPS Lite V1.2/V1.3 and the Pi Zero or Zero 2w.

The Dimensions of the case is WxDxH 75x25x36mm. It is smaller in all dimensions than a flipper zero with a case and just as thick as the flipper without the case.

For the components to fit, you need to make the “Slimagotchi” mod. With the Waveshare V4, you need to only remove the spacers of the pin header and cut the pins down. You do not need to mod the screen in any way.

You do not need any additional hardware, than the one that comes with the UPS Lite, to assemble it. If you do not have the screws, you need 4 pcs. of M2.5x10 screws and 1 M2.5 nut. I found that my UPS Lite came with too high screw spacers and I had to make 8mm spacers, to make it thinner.

The paracord piece, that I have used is: Zipper Pull for paracord 550 by PicoProject - Thingiverse.

I printed my case with PLA on a P1S with organic supports.

.f3d files are uploaded as well, so you can change it, how you like it.