Pwnagotchi Case (Print In Place)

Using Ya Ikou's Pwn-In-Place case as inspiration, I designed a new variant from scratch.

Built Specifically for this setup:

• Raspberry Pi Zero 2WH
• PiSugar3
• 2.13" E-Ink Display HAT V4

My perceived improvements over the original:

• Made loop hole bigger to actually be able to use a carabiner
• Moved the loop from the bottom to the top so you could leave a carabiner or other attached while still sitting flat on the table.
• Made model thicker so it didn't feel as flimsy
• Covered the Pi Power Port (not needed)
• Added hole to see the Pi status LED
• Added hole to see the PiSugar battery status LED.

It's a snug fit.  You'll need to insert the screen side first.

My Print Settings:

• Layer Height: .2
• Infill: 15%
• Paint-on Organic Supports

• Made loop hole bigger to actually be able to use a carabiner
• Moved the loop from the bottom to the top so you could leave a carabiner or other attached while still sitting flat on the table.
• Made model thicker so it didn't feel as flimsy
• Covered the Pi Power Port (not needed)
• Added hole to see the Pi status LED
• Added hole to see the PiSugar battery status LED.