Infinity Basic Terrain Set - MDF Like

Hi Everyone!

I designed this terrain set to fill a gap I saw when starting out with Infinity.   Loads of awesome high quality terrain is available both Printed and in MDF Cardboard but finding a full set for a table that was free, modular and stackable was hard to do.  

This terrain is built around Infinity N5 however can work for any miniature 28-32mm Scale game.  

Included in the pack are the following:

Buildings which can be printed with or without removeable roofs and with or without a ring of cover.  25mm Pegs can be used to slot in cover or full the cut out marks. I have also included building cover that's modular and either single corner or middle 1 side cover variants.  All prints fit on 250x250 MM printers, everything under 6x9 can be printed on 180mm printers, the sizes are as follows:
* 3x3
* 3x6
* 6x6
* 6x9
* 8x8 Objective Room with Wide or Narrow doors
* 9x9

Expandable bridges for S2 models or Wide bridges in both elevated or Flat styles.

Print flat stairs that can line up with both the buildings with Cover or without cover.

Ladders that can extend to multiple stacked buildings or single building.

Scatter terrain including:
Blocks
* 1x1
* 1x2
* 1x3
* 1x4
* 2x4

Vehicles:
*a fancy transport truck which can carry scatter blocks

Trash Bin with doors that open or close to put your underperforming mini in.

Signs:
* Ground level low Sign / Bench
* Ground level High Sign
* Building Sign / Extra high Sign

Everything prints without supports with a few small exceptions (truck body and Ladder Extensions)