(Updated) Hold-a-phone Simple Phone Holder

Update: The new version 2 allows most phones to stand vertically while only using a tiny bit more plastic and time. Check it out!

If you don't like the look of the zillion other phone stands, why not try this one out! It is best for holding phones horizontally, but tablets and large phones might reach both feet so could be held vertically.

Printing Tips:

• Infill: 20%+
• Perimeters: 2 or more (if 3+, no infill needed)
• Supports: None!
• Plastic: Only PLA tested so far
• Orientation: Right-side up

Other Notes:

• I would have shown a phone being held but my phone is also my camera
• I may add a big-footed version later so that I normal size phones can be held vertically