Case for MMU 3MS

My version of the case for MMU 3MS

The case is designed for use with the following devices

• BTT MMB board
• Feeder LERDGE
• Motor Nema17 (17HS4023)
• Led WS2812 10mm
• Cooler 3010 (12v > connect 5v)
• Switch OMRON D2F-5 for runout sensor
• Steel ball 5mm for runout sensor

The input sensor of the feeder requires modification. Instead of a resistor, install a jumper (red arrow). On the connector, use the two outer contacts. To fix the output sensor, use a screw (yellow arrow)

The case is designed so that the board, feeders, cooler, and wire entry can be installed in a mirror image, depending on the installation location of the MMU.

My projects that might be interesting with this device

• Blobifier for SV08
• 4 tube Y-splitter for MMU