Apple Magic Keyboard travel case

This is a remix of the Apple Wireless Keyboard 3rd Generation case - https://www.thingiverse.com/thing:2673738 - but the remix-source-finder does not allow me to select this one.

My contribution:

Created a 3rd part, an extension, to fit the keyboard with numeric keypad for printers that are not able to print at 250-ish mm height.
It is based on the "small" version (for keyboards without numeric keypad).
The "middle" part is the remix, the top and bottom are included for convenience.

Please make sure you like and share Tanemahuta's design!

Be aware:

This case, like the original, is only suitable for the "wedge" shaped keyboards with built in rechargeable battery.

Printing tip: use a (around) 10-line brim on the middle part because the contact area with the printed is very very small. I printed all parts with a brim, but in fairness, the bottom and top, which print on the closed side, should have enough adhesion without a brim. (I just didn't want to waste a 28 hour print ;) )