Snowmote - Case for Pubmote Project

3d printed case for the Pubmote project, a VESC onewheel tilt remote.

Hardware Requirements

• 5 x M1.7 screws
• CowPowerSystems development PCB
• LilyGo T-Display S3 Amoled (1.43in)
• PS5 Hall Joystick
• Battery (this one fits the 51mm x 31.25mm x 9mm holder)

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

• 30%-50% infill, so the large, flat areas are sturdy
• Face down on the bed, so no supports are needed

Assembly Instructions

Once it's printed, remove from the bed and assemble in the following order:

1. Place battery into its case (if desired) and zip tie this to the Floor piece

2. Install data wire between main PCB and joystick breakout board

3. Install main PCB and joystick breakout board on Floor piece

4. Connect power to LilyGo display and install onto main PCB with the UCB-C port on the display facing away from the joystick

5. Close lid over top of assembled board and snap to fit together

6. Install a lanyard if you like!