Strong Ceiling Grid Hooks

Yes, another ceiling grid hook but these are strong! 💪 There are multiple sizes available and I'd be willing to make more upon request. 😁 The hooks are printed in two halves and are joined with a “live hinge” which the halves fold together along. As you close the hinge, the ends clamp round the ceiling grid. Once set in place, make it permanent with a zip-tie! These are designed with just enough tolerance to slide along the grid even after being zip-tied in place.

Be sure to clip off the integrated supports (as shown in the GIFs) before mounting! ✂
Print the STLs as oriented.

I hope you find this print useful and please post your makes! 

Material: PETG - Or stronger filament. PLA with deform over time.

Layer Height: 0.2mm - Lower for finer layer lines.

Perimeters/Walls: 3 - Add more for more strength.

Infill: 15% Cubic - Increase for more strength.

Brim: NO BRIM - This could interfere with the live hinge design.

Supports: NO SUPPORTS - Necessary supports are in the design. Clip off before use.