Yorick

Yorick is a fully 3d printable Mega XL stringer hand cannon that requires no extra hardware other than the elastic string. This Blasters fps will depend on the elastic put in it but with the 1/8th inch elastic I have, Yorick averaged around 70fps.

Printing WILL most likely require supports
The print settings I used were 5 walls and 20% gyroid infill and default supports but this probably should change depending on your setup.

Use a piece of filament as the trigger rod.

As seen on the #50 episode of the Foam News Collective! 

This was made by me, DuBois, callsign DB.
Questions or suggestions? Email me at: DBnerfstore@gmail.com
If you like my designs, and want to support any future designs, consider buying me a coffee at https://buymeacoffee.com/dubois
All donations go directly into a savings account for my future mechanical engineering degree!