Bell Pull, Cord End, Mini-Ornament for Christmas

This is a bell shaped pull, cord end, or miniature ornament, designed to be attached to the end of festive string. It is small and prints quickly. I printed with a 2mm brim, inside and outside, just to make sure that these small pieces stayed in place, and also to improve the overall print quality.

I designed this model to be at the end of a string, which when pulled, would rip through a perforated section of a gift wrapper that I placed on a 100g Toblerone bar. See photos.

I used Bolevecká základní škola's original shape of a bell because I didn't want to spend a lot of time with that aspect of the design. I don't know if this is a generic bell shape, or custom designed. However, I did not use any of the fill patterns. I made these additional changes:

• I reduced the dimensions to fit my application.
• I made bell shaped cut-aways for the body and clapper.
• I reduced the size of the top eyelet/hole so that it would be smaller in diameter, but still accept a 2mm string.
• I made a cupped cut-away at the eyelet/hole to accept a knot in the string.