With this tool you can make nice decorations for the gift boxes etc.
Phases, see picture titles:
- Two body rings bottoms up
- Press them together, smaller to top, see the orientation
- Turn unit top part up, add position 1 finger
- Place rest of the fingers
- Pull end of the ribbon through the hole, go around finger ‘1’ and continue to the finger ‘2’. See rotation direction
- Continue following the numbering (jump to every third finger) half a dozen layers
- After enough layers (example item has 7) is done turn unit over
- Hold ribbon thigh through the middle hole and remove fingers pushing them down. Remove also rings
- After the all plastic parts are removed, stable bow's center. Pull fingers ribbon layers out one by one
Tags
The author marked this model as their own original creation.