Prusa MK4/MK4S Bed Test

This a simple way to test if you mesh bed leveling is working. It can also clear any gunk that is stuck to the bed to get a clean print bed.

I recommended speeding the first layer speed in prusaslicer to make the print go a bit faster. The premade gcode is set to 150mm/s, but you can speed up the print or slow it down. I recommend 150-200mm/s.

Prints in less than 30 minutes and only uses 13 grams!

Printing Settings:

    More designs

Angry Crab Knife Holder	Little Vase	Bed Test