A versatile sink drain strainer designed for sinks with an Ø82, Ø86, or now Ø90mm diameter, featuring an integrated plug. The press-fit design accommodates a drain plug stem that fits most modern drains (Ø8mm) and includes a gasket for a secure seal, allowing you to plug the drain without removing the strainer. This innovative design prevents clogs while simplifying water retention. Assembly is quick, and the strainer can be glued for added durability.
Features:
- Fits Ø82, Ø86, or Ø90mm sink drains.
- Integrated plug support with a press-fit stem.
- Gasket ensures a reliable seal for plugging the drain.
- Maintains its straining functionality even when used with a plug.
Printing Recommendations:
Recommended materials
- Strainer & Stem: PETG (ideal being normally food-safe and heat-resistant)
- Plug: TPU
Settings
- Layer height: <0.2mm.
- Supports: Not required.
Assembly Instructions:
- Print all parts as per the printing recommendations.
- Place the plug onto the bottom with the lip side of the plug towards the strainer.
- Press-fit the drain plug stem into the hole on the strainer.
- Optionally, apply a small amount of glue for added security if the press fit feels loose.
- Test the strainer and plug in your sink to confirm proper sealing and functionality.
Maintenance:
- Regular Cleaning: Rinse thoroughly after use to remove debris. Use mild soap and a soft brush for cleaning.
- Deep Cleaning: Soak in a vinegar-water solution monthly to dissolve hard water deposits. PETG components can even be cleaned in the dishwasher.
- Inspect and Replace Gasket: Periodically check the gasket for wear and replace if necessary.
- Avoid Harsh Chemicals: Use non-abrasive cleaners to preserve material integrity.
Other Models of Interest:
Revisions
- 2024-12-05: Initial release.
- 2024-12-10: Rotated parts for easier printing.
- 2024-12-15: Added Ø90mm version.
- 2025-01-15: Reduced heights of 82mm & 86mm strainers, improved press fit of stem, added some radiuses to make it easier to clean and to make it slightly more rigid
Tags
Awarded in the contest
256 entries | November 29 – December 15, 2024
The author remixed this model.
Differences of the remix compared to the original
- Lowered height 8mm to be compatible with the drain plug and stem.
- Removed drainage holes as the bottom towards the plug
- added hole at the bottom of drainstrainer to press fit drain plug stem
- Improved the stem design to print horizontally to improve strength
- Added a gasket working as a plug when strainer pushed all the way down
- Added a 86 and 90mm version