19cm network rack

I wanted to organize our small pile of home networking gear, so I designed this 3d-printed rack. From top to bottom, it holds:

• Feed-through patch panel with slots for 9 keystone jacks
• Cisco SG250-08 L3 managed switch
• GL-iNet GL-MV1000 router running OpenWRT, in a custom case (also included)
• HP EliteDesk 705 G2 Mini PC

There's space in the frame for one or two more pieces of gear, and I zip-tied a power strip in the back so that all of the wiring is contained inside the frame.

All of the parts are designed to fit on a Prusa MK3S+ printer, in PLA.

Hardware required for the frame:

• 24pc M3 socket head screw, 24mm length, fully threaded
• 24pc M3 4x10mm hot melt insert nuts

and for each mounting plate:

• 4pc M3 hex socket countersunk screw, 20mm length
• 4pc M3 4x6mm hot melt insert nuts