Sock clip hanger / věšák na sušení ponožek

Inspired by this design:

• https://www.prusaprinters.org/prints/53299-sock-clips-improved-v3-for-drying-rack

Adjusted:

• Diameter to for ~12mm rod (metal drying rack side bar) and ~14.3mm rod (main frame)
• Shape of hooks - prints as 2 lines (use 0,5mm extrusion width) (no gap fills)
• Sufficient attachment (previous version broke, so I made it larger again)
• Hooks shaped with closing gap. 
  1st gap wider, 2nd gap narrower (works better for panties)
• Made to fit Prusa MINI print bed (bit less than 180mm) (Set skirt loops to 0)
• Attachment to main frame (14.5mm) split to allow hanging wires go between. You can place in short side of hanger.

Print in PLA if you want to use it indoors and not on direct sun. PETG is recommended for outdoor use.