Creality K1-Series Btt SFS V2 Mount

BOM:

1. connector 2x - PH2.0
2. 1x - smd 0201 100R resistor
3. screw 4x - M3x6

The kit includes XH2.54 connectors, you need to change them to ph2.0, Crimping Tools is required.

Installation of a resistor 100ohms, there are 2 options for further implementation

Option one, install smd 0201 100R resistor,  i circled the installation location in the photo

Option two, install a regular resistor like CF-100 in the gap of the blue wire, and close everything with heat shrink, the resistor rating is 100 ohms

Klipper settings:

[filament_switch_sensor filament_sensor]
pause_on_runout: true
switch_pin: ^PA7
runout_gcode:
  {% if printer.extruder.can_extrude|lower == 'true' %}
    G91
    G0 E30 F600
    G90
  {% endif %}

[filament_motion_sensor encoder_sensor]
switch_pin: ^PC15
detection_length: 5
extruder: extruder
pause_on_runout: true
runout_gcode:
  {% if printer.extruder.can_extrude|lower == 'true' %}
    G91
    G0 E30 F600
    G90
  {% endif %}

Print without supports

I got the installation information here

BigTreeTech smart filament detection module github

P.S.

I used what was available smd 0805 100R resistor

Redesigned mount for Btt SFS V2