There are many dev board setups which have a user defined layout for certain devices.
This is great if you need that exact one. However if you need to change it up for another device or controller then you are a bit stuck or need to reprint.
I have made the following modular setup.
You need to print the main holder and there is also a storage holder.
Then print which ever tile you need and slide it in. (Tolerance is not tight so people don't have to worry about tiles being stuck)
Stick the breadboard in the middle and off you go.
Please drop a note in the comments for more, I will upload as I need them or by request.
This uses M3 screws with no threaded inserts due to the size of the mounting hole being too large with one. The hole size is 2.9mm and should be ok depending on your printer tolerances.
Included files so far are;
The author marked this model as their own original creation.