BetaFPV AIR65 TPU Canopy

Une nouvelle canopy à imprimer en TPU pour le BetaFPV AIR65
22
255
1
1146
updated November 12, 2024

Description

PDF

Remix from “Air65 Canopy (low angle)” by raNn.

Une nouvelle canopy à imprimer en TPU pour le BetaFPV AIR65 :

  • Incassable
  • Permet des tilts beaucoup plus bas

Attention : Ce n'est pas indispensable, mais une impression “dur” facilitera les choses, quelques pistes :

  • Utiliser des TPU moins mous que d'habitude
  • Chauffer le TPU et le laisser refroidir pour qu'il durcisse un peu
  • Le badigeonner avec un peu de glue
  • Une version renforcée en 2mm est disponible

Dans Betaflight, ajouter un filtre notch statique :

  • Fréquence centrale : 200 Hz
  • Fréquence de coupure : 165 Hz

 

English :

A new canopy to print with TPU for the BetaFPV AIR65 :

  • Unbreakable
  • Allows much lower tilts

Be careful : It is not mandatory, but a stiffer print will make things easier, a few ideas :

  • Use stiffer TPU
  • Heat the print and let it cool down to harden it
  • Spray glue on it
  • A stiffen version (2mm) is available

In Betaflight, add a static notch :

  • Central frequency : 200 Hz
  • Cutoff frequency : 165 Hz

🛒 Acheter le BetaFPV Air65 🛒

Tags



Model origin

The author remixed this model.

Air65 Canopy (low angle)
by raNn (thingiverse.com)
 

Differences of the remix compared to the original

Stiffer versions to limit vibrations.

License


Highlighted models from creator

View more