Archery - arrowhead & arrow extender

Info Both designed for 8mm arrows. I print arrowhead with 100% infill PLA and it works fine. For more durability, you…
40
235
2
875
updated August 8, 2022

Description

PDF

Info

Both designed for 8mm arrows.
I print arrowhead with 100% infill PLA and it works fine. For more durability, you can use etc. PETG, ABS.

Recommended usage:

  • Use the extender as close to the tip as possible for maximum efficiency (picture 3, method 3). If you use method 2 from pic. 3, arrow will break after small shake. (I tested shoot with it, and it survived one shot. It broke in my hand after few seconds.)
  • You can use tape for smooth transition between extender and arrow body or wrap the entire extender. 
  • IMPORTANT: I use super glue to connect two arrowheads, although you can wrap the entire extender in super glue for more durability -recommended.

If you do not follow the recommended usage, the extender is more likely to break as follow in picture 4.

Print Settings

Rafts: No

Supports: No

Resolution: 0,2

Infill: 100%


Filament: PLA/PETG/ABS

Category: Sport & Outdoors

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License