Cat Skull Hair pin

Printing it vertically was the trick for the skull! My girlfriend loves this model. Printed in Overture Pink PLA

Split the model down zhe middle and used dowels for alignement.

Daughter love it, amazing model too, thanks for that

Took me a couple of prints before I figured out the proper orientation of the skull but once I got it right it’s an easy print! Absolutely LOVE the design! Thank you!

I print the skull standing straight up on the teeth. No raft. Big brim. Organic supports.

The bone printed flat with snug supports enabled.

I printed it for Halloween.
I resized the clip bone and make it 15cm wide.
Tried different positions to print it, found like this was the fastest and with best quality.

Nice and smooth

I flip face down the skull and the print is bad :D

Printed perfectly!

Printed on MK4, surprisingly in almost vertical position with decreased need for supporting material. The print is nice and you cannot see any marks after the supports were removed. Printed on 0.15 STRUCTURAL settings with slight adjustments due to the filament (PLA from Nebula). Especially, the skull is in 100% size, the pin around 97-98% but even slightly lower scale would work even better. Personally, I would guess around 95%. (edited)

Cool model!