Fit is absolutely perfect, much appreciated! Ended up using some zip-ties to mount it to the bottom of this weird Acer monitor mount.
PIR HC-SR501 Housing Without Extension
Remix of the HC-SR501 with extension. I removed the back but included a slight gap in the back for cable to run…
10
175
4
749
updated December 25, 2021
Makes
Comments
Printed without support. Needed some force to put the board in, but it fits well. As mentioned, I had to bend the pin header.
Quick test print with some generic PLA.
The sensor fits quite well but I had to bend the pin header a little to get it in there :) (edited)
I was able to print this with default setting in prusa slicer. I printed with a quality defined selection at .1mm. I'll include the gcode file I used.
