iGulu F1 Keg Pressure Relief Valve Opener

The pressure relief valve should stay open if you want to use your iGulu F1 Kegs for fermentation projects that require constant air exposure, such as Kombucha. 

This handy little gadget does just that. Pull the pressure relief valve up, snap on your printed clamp, and it remains open as long as you leave it there. It is designed with just the proper tolerances to firmly snap onto the pressure relief valve and keep it up as much as possible - while trying to avoid unnecessary strain on the mechanism. Printing is very easy and fast, and I find them super helpful.

Designed specifically for this Keg: https://igulu.com/collections/accessories/products/igulu-f1-fermentation-tank

PRINT SETTINGS

• Filament - Bambu PLA Tough
  • with Bambu "0,16mm Optimal @BBL X1C" print profile in OrcaSlicer + modifications below
• Layer Height - 0.16
• Wall Loops - 4
• Infill - 100%
• Top shell layers - 4
• Bottom shell layers - 4
• Wall Generator - Arachne
• Prints fine without a brim on the X1C, but it wouldn't hurt to add one

Disclaimer:

The iGulu F1 Keg's pressure relief valve is most likely not intended to be kept open for an extended period, and this tool might damage or put unwanted strain on the mechanism. Use at your own risk.