Knomi fan shroud for FlashForge Adventurer 5M

I created this to allow mounting the Knomi V2 in my 5MPro (you must be running KlipperMOD to get actual data on Knomi…see below).  It will work in normal 5M as well and a Knomi v1 and opens intake venting along the sides and places the Knomi just infront of the stock fan.  I should have made it work with a 5015 fan (maybe future remix).  I also created custom FW that has replaced the Voron logo on the Knomi with a custom made sliding FlashForge icon for the start up.  I had to put in a 24v→5v regulator to use the fan supply for the Knomi power, but it works great and no restriction on airflow.   I actually designed in better part cooling ducts (more balanced) too and better clearance.

In order to actually tie the Knomi v2 display into the FlashForge Adventurer 5M, you will need to be running the KlipperMOD which allows for moonraker data to be scraped.  There is more info here: https://github.com/xblax/flashforge_ad5m_klipper_mod

No supports needed, print with face down on 0.2mm layer and 20% infill.  I did ASA, but ABS should be good too.  I may supply the custom FW I build here or provide a link later if there is interest.  For mounting, you just use a little hot glue to hold the Knomi in.  Uses 5x2mm magnets just like original.  You can harvest those or install new ones.  Press fit seems good, but I would still super glue or hot glue them in.  This model does require you to remove two screws at the top front of the enclosure for clearance.