Gridfinity Laptop Riser with Drawers 2 by 4x5

Nice simple laptop or monitor riser with two built in 4x5x10 Gridfinity drawers and mounting for a 56mm MagSafe charger. The two drawers print separately and slide together with a dovetail joint. You can use them together or apart depending on your desk setup. Use a little drop of CA Glue to permanently join the drawer modules.

Print on standard 0.2mm layer height, 3 perimeters, 15% infill of your choice. Tree supports needed for MagSafe holder. The drawers are made to be snug. If they are stiff try moving them in and out rapidly to wear in the rails.  

Handles use 4x20mm M3 screws and heat set inserts

Magsafe charger holder mounts to either side (mirror file in slicer for right side) and uses 2x8mm M3 screws and heat set inserts. 

I used this knock off magsafe charger but the hole should fit the official Apple version as well.  https://www.amazon.ca/dp/B0BLKJJCBV?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1