Very Nice!
Locking Dummy 13 Stand
This stand locks to 45 degree increments and firmly holds there.
576
4451
18
9651
updated October 31, 2024
Makes
Comments
Looks awesome!
The stand feels a little overly tight, but I guess better tight than loose. Printed the stand using Voxelab PETG-CF.
View one more comment
@Shadymilkman makes sense - I did use a sharp blade to soften some of the rough spots very slightly thinking that would help, but not too much.
Unfortunately, out of the 9 rolls of filament I own, only 1 is PETG and it's the PETG-CF blend. I'll retry in the future with pure PETG. I just dislike printing pure PETG due to the gloppiness of it - the CF added ones just print so much smoother.
By floppiness you mean like stringy? I felt the same way until I realized I wasn't drying my PETG properly. I can't remember the YouTuber who mentioned it, gotta leave the dryer open a little bit. Anyway, that's just my two cents 😊
I was wondering if it would work without supports but It surprised me and worked well without supports :) printed in pla because I wanted to try it with my clear pla.
Yeah no supports needed just like the basic stand hehe. I guess I could've put that in the notes 🤣 (edited)
Works great with PETG, faster than the original and more sturdy so long as you use a durable filament. Only need one of the arms, though 3 are included. I use the symetrical one and delete the rest for faster print.
Nice work!