Ikea KNARREVIK Laptop Holder

We use a KNARREVIK side table next to our couch and it's not got a lot of surface area. My wife needed a place to put…
21
69
2
880
updated December 23, 2021

Description

PDF

We use a KNARREVIK side table next to our couch and it's not got a lot of surface area. My wife needed a place to put her Chromebook when she's not using it. The two pieces slot on to the existing screws which can then can be tightened down through the holes on the back. It should hold a laptop that is up to 22mm thick. The holder is designed to be wide enough that the laptop should safely slot in no matter the angle or how off center it is when you slide it in.

Print Settings

Printer:

Creality

Rafts:

No

Supports:

Yes

Resolution:

.32mm

Infill:

20%

Filament: Sunlu PLA+ Black

Notes:

I printed this with a 1.0mm nozzle and it came out great. Make sure to print it laying on the long flat side for each piece to avoid needing lots of supports. Only the screw holes should need any support. You might be able to get a good print with no supports but I didn't test it due to the amount of material it would waste.

I'll probably re-print with some PETG when I get enough black in to complete the print.

Category: Organization

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License