Raspberry Pi 7 inch LCD stand, Now with Tabs!

Wanted to use this stand until I received a bamboo one I ordered, but I didn't have screws. I added tabs in front of the screw holes that go underneath the raised holes on the screen. Also added a small lip at the bottom to support the screen (not the glass). The screen will fit either right-side-up or upside-down but works better upside-down. (Designed that way due to power to the Pi)

Print Settings

Printer Brand:

LulzBot

Printer:

TAZ 6

No

Supports:

No

.18

Infill:

20%

Notes:

Supports would be helpful, depending on your filament. I had them turned on, but Cura didn't make them all, for some reason. Still turned out ok in PLA with fans on