ADT UT3G EGPU Enclosure - 250mm GPU + 120mm Slim Front Fan Support

This is a slightly modified version of the original ADT LINK UT3G USB4 eGPU enclosure with the following changes:

• Adjusted height and length to support most dual-slot GPUs up to 265mm in length
• Adjusted width to fit a slim 120mm front fan (reduces GPU length to 250mm)
• Added small vent cutouts to the rear to allow better airflow for 120mm front fan
• Added support for Enhance 7660b PSU with a larger rear cut-out and side ventilation

Notes:

• I used an INNO3D 4070 Super and Enhance 7660b PSU from Velkase
  • This PSU needed an adaptor for the nvidia 12VHPWR plug - I used this adaptor from AliExpress which worked well and does not heat up much
• 120mm fan has exactly 2mm width clearance. This allows it to be mounted using 1mm-thick adhesive silicone strips on each side of the fan which create a perfect friction fit. No screws needed.
• Graphics card backplates are not compatible - this was an oversight and could be easily fixed, though.
• Another small hole was drilled into the central vertical plate to allow for cable ties - this could also be added into the model itself.

- Adjusted height and length to support most dual-slot GPUs up to 265mm in length
- Adjusted width to fit a slim 120mm front fan (reduces GPU length to 250mm)
- Added small vent cut-outs to the rear to allow better airflow for 120mm front fan
- Added support for Enhance 7660b PSU with a larger rear cut-out and side ventilation