Custom Nespresso Capsule Dispenser w/built-in Support

Remixed the F3D file to include a support for the long bridge section. While it says it can print without supports, I prefer to have custom supports that easily support and remove after print. Provides a very clean bridge without any possible sag.

Print Settings
Layer Height: 0.2mm
Perimeters: 2
Infill: 15%

I prefer to use PETG due to bed adhesion and rigidity of the filament.

Remixed the F3D file to include a support for the long bridge section. While it says it can print without supports, I prefer to have custom supports that easily support and remove after print. Provides a very clean bridge without any possible sag.