Tinmorry Spool Adapter - Ender 3v2

TINMORRY FILAMENT SPOOL ADAPTER - 31/54
Customised using openSCAD as thingiverse is just plain broken.

This is a customised print for a loose fit on a standard ender 3v2 spool holder, but nice and tight in the Tinmorry spool.

IMPORTANT NOTE: Due to the design of the spindle on the v2, you cannot simply slide these on !!!!

To make these work, I cut the end off the back of the tube at the cuff. I drilled a single hole through the tube to allow me to fit a split pin or similar to stop any chance of the filament spool sliding off.

Combining 2 of these withPTFE tape wrapped around the ender spindle provides a nice, low friction solution without the cost of bearings etc.

Inside Diameter of adapter: 31
Outside Diameter of adapter: 54
Arm spring 1.4mm
6 arms straight.

Printing Guide

You can print with/without a brim - I used a brim as the arms have a tendency to want to warp, but usually stay down fine for the print, but brim cleanup is pretty trivial.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

10

Filament:
Tinmorry PLA Black

Notes:

Customised using openSCAD as thingiverse is just plain broken.

My attempt to use customiser, when I can get it to even load (not in Chrome on Linux, only on IPAD Chrome) the queue never processes the work ...

Category: 3D Printer Parts