QIDI XPlus3 Side Filament Sensor Mount

A new filament sensor mount for the QIDI XPLUS3 to make it accessible from the front of the machine, making filament changes easier.

You'll need a longer Bowden tube to replace the original one that goes into the hotend and an extension for the filament sensor wiring (Remember these wires are shielded, use something decent as per Ethernet Cat7 or so that comes shielded and wired in pairs, will save you a headache)

It's been designed to accommodate M3 heat inserts on the sensor end, and some M3x12-14 hex screws… heat inserts make this part more durable.

Print it in some sturdy material such as ASA, PA??? or something like it…PLA might work too, but I can not guarantee it will last in time.

Other than that, it's an easy upgrade.