Spring Valve Marching Baritone Keychain

So many revisions... but it works! Inside I created a spring to press down the valves on this baritone. It's got .3mm clearance on the sides and 0.5, between vertical surfaces, so it prints in place without any pauses or anything else needed. Once it's done, you should be able to press the valves down with a little force at first.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

No

Supports:

Doesn't Matter

Notes:

Shouldn't require much work, just good print settings. I used the tiny amount of supports cura automatically generated underneath the valves and that seemed to help. Like I said above, it has a 0.3mm gap in the XY and 0.5 in the Z, so hopefully your printer can make that work.