Have you ever thought to yourself, "man, if only my mouthpiece was 11.8 inches longer I'd be such a better musician"? Well I'll be darned, you're just in luck! Measuring 380mm (15 in) just find yourself a nice big 3d printer and get movin.
It's been 4 years since I lasted played it, but if I remember it tuned the trumpet down more than a full step. I'm 6'1" and had to hold my arm fully extended in front of me in order to play it too haha.
Printer Brand:
Creality
Printer:
CR-10
Rafts:Doesn't Matter
Supports:
Yes
Notes:
You need a large bed most importantly. The CR-10 I have has a 300 × 300 mm bed, so I designed this one to fit corner to corner there. Make sure to have your settings dialed down though, I was under extruding and it wasn't completely watertight so I was losing a lot of air out the sides of the mouthpiece. Use supports "touching buildplate" so you don't have to clear the inside, which prints just fine.
I'd really love to see you post a make if you end up printing this!
The author marked this model as their own original creation. Imported from Thingiverse.