AeroShnell RM–TS is a shell for a Rear view Mirror with Turning Signal included for your velomobile.
Additional parts needed
take the main shell and insert a round 10×6 mm magnet
glue in part MagnetStopper to keep the magnet in place
take a yellow 8 mm Power LED, insert it into LED_Traeger with legs bent, solder on wire (not shown here)
screw on LED_Traeger and LED inside the shell – no glue! Route the wire outside through the front bore in the foot.
now take BlinkiGlas and glue on AntiReflektor …
… and screw both onto the shell
put a 10 mm magnet pall inside SpiegelTraeger
glue SpiegelSchutz_TPU onto the back of the mirror and then both onto SpiegelTraeger
now put SpiegelTraeger inside the shell, the mirror should be adjustable to any angle
put TPU_Fuss unter the foot for compensation when mounting AeroShnell on a non–planar surface; inside the velomobile shell, GegenPlatte can be used as a (guess what) counter plate; BohrSchablone_PLA (not shown here) is a drilling template
use a M5 bolt to mount AeroShnell to the velomobile and connect the wires to your vehicle's electronics.
Have a good ride and please post a make if you build one of these – include a photo of AeroShnell on your VM.
—eof—
The author marked this model as their own original creation.