Picatinny Rail for Walther PPQ CO2 Pellet Pistol

Add a picatinny rail to top of your Walther PPQ M2 air pistol.

This will allow you to mount a red dot sight, or other picatinny-supported accessories.

Required:

• the screw from the included sight on the pistol

Installation Instructions:

1. Remove the included sight.
2. Remove the screw from the included sight, and store the sight in a safe place.
3. Insert the 3D printed picatinny rail over the sight mount.
4. Insert the screw from the original sight into the side with the larger hole.
5. Carefully apply pressure until the threads catch, then carefully tighten the screw until it's all the way through.
6. Do not over tighten.

Notes:

Given that the sight is held by only a single screw, at the back of the mount, I'm not sure how durable it will be. Always be sure to securely hold the mount when removing things (i.e.: when removing the dust cover from your red dot sight, you could break the mount).

Printing Instructions:

• (recommended) print with 100% infill, in the hopes of making it stronger.
• print it rail-side down, with supports on the base plate.