CalDigit TS4 Bracket
Ender 3 Pro
1
October 7, 2022 at 2:04 PM
Original model
Comments
@JasonLang_99641: what about including a paper installation template? The template could help with alignment and pre-drilling holes.
@dfredell I would advise against the bridge due to the amount of heat coming out TS4.
@dfredell It would be harder to print if connected, but I might create a jig to align it properly.
Fits great. I didn't have those specific screws and my standing desk table doesn't easily allow screwing into. So I used Gorilla glue, same as E6000.
It was a little tricky to get the mounts alighted, my suggestion is to have a version where the two sides are bridged together.