ODROID N2/N2+ Wall Mount

This bracket for the ODROID N2/N2+ makes it super easy to mount on a wall. This version improves on the original design by introducing a sacrificial layer for the mounting holes which eliminates the need for supports when printing. 

This version also increases the distance between the N2/N2+ and the wall which allows for better airflow across the heatsink. If one wishes to mount the N2/N2+ closer to the wall, simply split the model at the desired height in your favorite slicer prior to printing.

Secure the left and right brackets to the N2/N2+ heatsink with four M3 x 30mm screws.

If you are looking for a printable case for the N2/N2+ check out my case here.

The OROID N2/N2+ is a fantastic single board computer with roughly 2x the power of a Raspberry Pi 4. The N2+ powers the Home Assistant Blue device and I highly recommend it.

Printing

• Print in PLA, PETG, or PC. If the N2/N2+ will be in warm conditions or overclocked consider using a heat-tolerant filament like PETG or PC instead of PLA.
• Print using a .2 or .3 layer height.
• Use 4-6 perimeters/shells.
• STLs are pre-positioned in the correct print orientation.
• Supports not required.

Happy Printing!