I rotate 90 degrees, increased 1,5mm of the lock and made the hook that rests on the printer thicker, about 1.5mm (previously it was 1mm).
In addition to these other changes, I placed the Letters K1 on the side of the spool holder
PLA Revolution Carbon
Printed with a Regular 0,6 Vulcano nozzle on K1
Sliced with OrcaSlicer.
No Supports
0,25mm layer height
3 Walls
35% infill Tri Hexagon
Took 59 minutes to print
23mm3/S Volumetric Flow Rate (i have some extrusion issues with more than 24mm)
Der Autor hat dieses Modell remixed.
I rotate 90 degrees, increased 1,5mm of the lock and made the hook that rests on the printer thicker, about 1.5mm (previously it was 1mm).
In addition to these other changes, I placed the Letters K1 on the side of the spool holder