Hinged lid for adding MMU2S to Original Prusa Enclosure

Printable accessory, providing access to the printer and MMU from the top. Designed for the Original Prusa Enclosure.
8h 32m
2× Druckdateien
0.30 mm
0.40 mm
164.00 g
934
8203
216
27 k
aktualisiert 5. April 2024

Beschreibung

PDF

Printable accessory for Original Prusa Enclosure developed to enable access from the top. Can be used for a standalone printer or for a printer with a multi-material unit on the frame.

Check the step-by-step guide on how to install the Hinged lid.

In case you want to use the Hinged Lid without the MMU you can use Hinged-Lid-Complete_0.3mm_PETG_MK3S_5h58m.gcode or you can turn off MMU-grommet in the 3mf file

In case you want to use the Hinged Lid with Advanced Filtration System you need to print Hinge-bracket-Rt instead of Hinge-bracket-R

To mount the Hinged lid you will need the following fasteners*:

  • M3x8 screw (15x)
  • M3nS nut (1x)
  • M3 nut (8x)
  • Pin 3x20 (2x)

* The package of the Original Prusa Enclosure includes extra fasteners, which were added in case you wanted to install the Hinged Lid.

 

Print instructions

You have three options:

  • use the pre-sliced G-code and print it on your MK3S+
  • use .3mf file for accurate setting of perimeters and supports
  • download the latest PrusaSlicer and use the following settings**:
    • print settings: 0.30mm DRAFT
    • filament: PETG (tested on Prusament)
    • 20% grid infill
    • minimum of 8 perimeters
    • turn on thin wall detection

** Note that this setting is the minimum possible due to the strength of the parts, but you can experiment with your own settings.

Tags



Herkunft des Modells

Der Autor hat dieses Modell als seine eigene Kreation gekennzeichnet.

Lizenz


Hervorgehobene Modelle des Erstellers

Mehr anzeigen