Needed one of these for a miniature I’m building. Wheels are printed in Timberfill while the cart itself was in PLA Mukha, both from Fillamentum. There was no way to get a 90 mm long cart out of wood as well.
The first thing I see is that your holes are in the wrong location. A little research will tell you the optimal place to put your holes, which is a certain percentage in from the ends (I think it might be 25%, but you should look it up).
I will look that up.
Don't print it the wing prints horribly on the prusa mini/+
Only the body printed good. (edited)
View 2 more comments
@Gminecrafter_674287 I just tried increasing the thickness of the wings so hopefully it worked. I will let you know when it is done printing.
@chrisgabb_575157 I printed it and it worked but did not fly (edited)
For me unprintable because, wings are not on ground. Need a lot of support and makes not sense for me. sry
Have you tried putting supports on?
