Perfect for our test bench to put devices in.
Thanks for the model! (edited)
Printed this model with Eakins microscope. Added camera cold shoe mount on the top and experimented with a few adapters to mount a 7in HDMI LCD on the top. The bolt used for Eakins scope is 8mm and it does not require a nut on the other end. I'm very happy with the result.
Printed this model with Eakins microscope. Added camera cold shoe mount on the top and experimented with a few adapters to mount a 7in HDMI LCD on the top. The bolt used for Eakins scope is 8mm and it does not require a nut on the other end. I'm very happy with the result.
I had a bit of elephant's foot on my prints and had to trim the insides to get the switch to fit. I forgot to mirror 2 brackets so my tops and bottoms don't quite line up. I'm mounting the switch in a gap between the wall and the end of a workbench so it doesn't matter in my case as you can only see the front, top bracket. I put a couple of velcro ties through the slots on the bottom brackets to help guide the cables that go behind the workbench.
@NevarroGuildsman Glad to see it worked - I forgot to mention that those slots are there for just that use case! :)
Nice design. Thanks for adding. My only comment is that the nickel-coated neodymium magnets will often, eventually rust out. I find the best match for aquarium use are the fully plastic coated magnets like: https://www.kjmagnetics.com/proddetail.asp?prod=B888PC-AST