Looks good, thanks :)

Printed it for dragon burner v7 and had to place spacers because turns out extruder now 2mm closer to the back

Worked perfectly thank you.

Won't quite fit V0 bed :(

So I made a smaller one that match my others for the front.
I'm the one who made the Snow knobs. (edited)

Clever design! Are you willing to share the step file? I'd like to make a few modifications.

Fantàstic. Queda molt rígid i està molt ben resolt

Fitted perfectly to my hypercube/voron trident mashup printer

I expected nothing but ran shaping calibration with and without these feet and it actually made a substantial difference to the recommended max accelerations. Should probably do more tests to make sure it wasn't a fluke but both X and Y got about 20-30% improvement over the "stock" hard rubber feet.

But, I did slightly break one foot. The walls are not very strong so probably best to print in something with stronger layer adhesion than the filament I used.

Printed in black abs.
60mm sunon fan.

The model was printed with PETG by esun.
The print is very good and the door fits very well.
I close the door with a magnetic catch