Black PLA, 0.12 layer




Does this hold ps5 controllers? Or could you make it with the Playstation logo
Thanks for fixing this print. I've just printed a 71.7% version for a broken usb lamp I had!
The cap is co-extruded purple gold but is red when lit! The vase mode was 0.8 walls and 0.2 layers. The fin at the top as you said needed more layers but is fine.
I modded the cap in tinkercad to be hollow to allow light from the base through.
I printed a long cylinder to help diffuse the light which I like.
Hi, good design, but...
are you sure you uploaded the right files? Part1 and part2 doesn't seem to match. (edited)
@kolstr Wow... I'm so sorry I accidentally uploaded the same part twice.
This is fixed now.
Made one for my granddaughter (her 1st born son) and one for my daughter (her 1st born daughter).