great model, printed with abs 100% infill
Great design. I use superglue quite often for some muli-part projects that are not bolted together and this has been great for keeping the glue in the same spot.
I had to adjust fit a little bit with sandpaper as grease could not fit initially.
Do you use double-sided adhesive tape for fixing? I printed out the part, it goes in fine but falls out.
@szym6r_2601733 Hmmm, the print should fit nicely in the back. You can try scaling up the model by 1-2% and see if that helps. I am sorry about the inconvenience this caused you.
Nice way to fill the hole left when I moved my spool holder to the side of my K1. (edited)
Certainly works better than the stock foot