Gut, aber die Rillen, die den Trockner halt werden nach der Zeit abgenutzt sein.
Filament: PolyTerra PLA
Slicer: Flashprint
Temps: 215 C Nozzle 60 C Bed
Layer Hight: 0.18
Infill: 15% Lines
Print Long Side Down
Great model, really stable, and phone can be removed from the holder without disconnecting. (edited)
Perfect sizing for both the canister and the straw holes, which are a very handy addition to this model.
40% gyroid 3 walls for all parts. Holding my older 24" samsung strong for over a month now. Saved me over 20 bucks on buying a mount, and the printed bolts saved me a few bucks and a trip to the hardware store. Changed up the wall bracket a bit to give it more strength. (edited)
@ectospray_699062 Printed bolt lasted about 4 months before i noticed it was shearing, then finally broke and fell at around 6 months. all other parts were undamaged, but i haven't gotten around to putting it back up yet.
Great model. Used a Mk4 and black Duramic PLA Plus, 0.2mm layer height on everything. I printed the arms with 5 perimeters and 50% infill and they are rock solid. I modified the wall mount to shrink its footprint so it'd fit in about 1.5". For the bolts I printed no infill, 3 perimeters. I scaled them up to 110% so they have a very snug fit through their holes. This resulted in less sag and a stiffer overall feel which I liked. Lastly, I combined a couple of the models to make a new VESA 75 mount that allows for tilt but not rotation (printed at 50% infill and 5 perimeters). I put a bit of white out on the two mating surfaces for the tilt to give more friction and hold the monitor in place as the plastics bots and nuts don't allow for a ton of torque before stripping. (edited)
Thank you!