UPDATE: I have amended this pattern to allow commercial use! Please donβt forget to credit me if you sell your makes and Iβd love to see some creations as well, appreciate your support. Happy printing :)
@QuietMike thank you so much for uploading your make - this is the first time anyone has shown me a make of my own designs, so it means a lot! I hope you get plenty of use out of it. :)
This is the V2 variant of my pattern, with an Octogram Spiral top layer and the original 5mm fillet edge on the base. In case you were wondering, my favourite flavour so far is probably Grape Bubblegum, but I'm only just starting out on this journey. What's your fave?
nice! i'll print one for myself
@Mish just slicing the model now and noticed this; surely the only way to remove this from the case is by grabbing the sides - which may cause the whole thing to fall apart
@Magmabow fair point - a workaround might be to include a small circular hole or two in the the tray base; thus allowing a finger to pop it up and out? I can always upload a variant. :)