I really like that fan setup. Do you have a link to that STL?
Thanks!
@PNWPrints_376283 It is available on the youtube clip. Not my design and I didn't remodify that so I've simply linked to that designer's youtube clip. I believe there has been reposts of it over on Thingiverse however I didn't link them to respect the original designer of that modification. (edited)
This is a fantastic design!
I made some subtle changes to this because I don't have a CRTouch on the machine my Sprite extruder is installed on, the Tronxy XY-2 Pro.
I shortend the end that takes the touch sensor so that it would work with a BLTouch/3DTouch sensor instead. I also opened the two screw holes to take 3mm screws with nuts, rather than threading the screws into the plastic, and added an opening for replacing the probe tip while the sensor is installed.
Thank you so much for publishing this!
Thank you, for a simple fix to this huge problem. Well for me.. Then just set your y offset to 0. this was for my ender3v2.
Thank you again,
Brian
What kind of pot are you using? did you print them?
@Dafe_572571 Sorry I have not gotten back to you sooner. I have bought pots. Dimensions are mentioned in the description of the downloads.
Saves a lot of time and cost to simply purchase them. I don't think it's worth the material and cost when 50 pots are about $25 AUD.
The larger 51mm holders use pots bought here:
https://amzn.asia/d/a6YkNa6
These may not be that common in your location however are sturdy.
Pot holder hole dimensions were: 51mm top, 39mm base, and 50mm depth. The pot lip can get to 58mm without issues.
The smaller 49mm holders use pots bought here:
https://www.aquagardening.com.au/lettuce-hydroponic-net-pots-45-x-50mm
These are very common.
Pot holder hole dimensions were: 49mm top, 38mm base, and 50mm depth. The pot lip can get to 58mm without issues. (edited)